MULTIQUIP FS 1 Instruções de Operação descarregar pdf (Página 24)

PAGE 24 — MQ-WHITEMAN FS1 CONCRETE SAW — PARTS & OPERATION MANUAL — REV. #3 (04/24/03)

3. Check V-belt tension (Figure 16) by using a tension meter

(6.0 - 9.0 lbs) against the inside belt at a mid point between

the two pulleys, or by deflecting the center belt at a mid point

3/8” (10mm) - 1/2” (13mm).

Figure 16. V-Belt Tension

4. DO NOT over or under tension the V-belts. Severe damage

can occur to the saw and engine crank shaft if the belts are

over tensioned. A decrease of power to the blade and poor

performance will result if the belts are under tensioned (loose

on pulleys).

5. If the V-belts becomes worn or loose, replace them by using

V-belt part number .

FS 1 CONCRETE SAW — INSPECTION -GUARDS, COVERS AND V-BELTS

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 55 56

Sem comentários

MULTIQUIP FS 1 Instruções de Operação Página 24