Multiquip DCA45SSIU4F Manual do Utilizador descarregar pdf (Página 22)



OUTPUT TERMINAL PANEL FAMILIARIZATION



Loads can be connected to the generator by various

methods, output terminal lugs, camlocks or the convenience

receptacles (Figure 10). Make sure to read the operation

manual before attempting to connect a load to the generator.

To protect the output terminals from overload, a 3-pole,

110A main circuit breaker is provided. Make sure to switch

 circuit breakers to the OFF position prior to starting

the engine.

Figure 10. Connecting Loads

LOAD

NEUTRAL

GROUND

HARD WIRE

HOOKUP PANEL

LOAD

GFCI

RECEPTACLE

LOAD

CS-6369

TWIST-LOCK

RECEPTACLES

CAMLOCKS (OPTION)

Over Current Relay

An over current relay (Figure 11) is connected to the main

circuit breaker. In the event of an overload, both the circuit

breaker and the over current relay may trip. If the circuit

breaker can not be reset, the reset button on the over

current relay must be pressed. The over current relay is

located in the control box.

Figure 11. Over Current Relay

NOTICE

Remember the overcurrent relay monitors the current

ﬂowing from the 

to the load.

In the event of a short circuit or over current condition,

it will automatically trip the 110 amp main breaker.

To restore power to the Output Terminal Panel, press

the reset button on the overcurrent relay and place the

main circuit breaker in the closed position (ON).

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 97 98

Sem comentários

Multiquip DCA45SSIU4F Manual do Utilizador Página 22