Multiquip DCA45SSIU4F Manual do Utilizador Página 34

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
Vista de página 33

GENERATOR START-UP PROCEDURE (AUTO MODE)

DANGER
Before connecting this generator to any
building’s electrical system, a licensed
electrician must install an isolation
 Serious damage to
the building’s electrical system may occur
without this transfer switch.
CAUTION
When connecting the generator to a isolation (transfer)
switch,  have power applied to the generator’s
internal battery charger. This will ensure that the engine
will not fail due to a dead battery.
NOTICE
When the generator is set in the AUTO mode, the
generator will automatically start in the event of
commercial power falling below a prescribed level
by means of a contact closure that is generated
automatically by a transfer switch.
WARNING
When running the generator in the AUTO mode,
remember the generator can start up at any time without
warning.  attempt to perform any maintenance
when the generator is in the auto mode.
CAUTION
The engine speed switch must be set to the “High”
position when running in the  mode. Failing
to set the switch in the proper position can result in
damage to your generator when it turns on.
When starting generator in AUTO mode use the “Manual
Start-up” procedure except where noted (see below).
1. Perform steps 1 through 5 in the Before Starting section
as outlined in the Manual Starting Procedure.
2. Place the  (Figure 46)
in the AUTO position.
 Switch (AUTO)
3. Continue operating the generator as outlined in the
Manual Start-up procedure (start at step 3).
NOTICE
When the Auto Off/Reset Manual Switch is placed
in the AUTO position, the engine glow plugs will be
warmed and the engine will start automatically.
WARNING
 stop the engine suddenly except in an
emergency.
Vista de página 33
1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 97 98

Comentários a estes Manuais

Sem comentários